Matrix M100V Dokumentacja Pobierz pdf (Strona 12)

Matrix Installation and Operation Instructions

4.0 CONDENSATE DRAIN

This unit produces water as a product of combustion. Much of this water condenses on the heat exchanger and in the venting

system. All exhaust piping must be on a slope back to the boiler ¼” per linear foot of vent. Steps must be taken to ensure that

condensate does not collect in the venting system. Condensate must be drained from the boiler into a household drain.

Note: check with your municipality, or local gas compa ny to determine if

disposal of combustion condensate is permitted. In the State of Massachusetts

the condensate must be neutralized prior to entering a drain.

The following are important notes that must be taken into consideration when

constructing the condensate system:

DO NOT run condensate line outside. A frozen or blocked drain will cause the

condensate to fill the combustion chamber. This will result in a no heat

condition, as the unit will shut down, and damage to the flame sensor, and

components can occur.

NEVER use copper, steel, or galvanized piping in the construction of the

condensate system (condensate is very corrosive and will wrought most metals).

When a condensate pump is used or required, select a pump that is designed for

residential furnaces.

WARNING

FAILURE TO PROPERLY CONNECT THE CONDENS

TE LINE WILL CAUSE COMBUSTION GASES TO

ENTER THE ROOM, POSSIBLY CAUSING SERIOUS INJURY TO OCCUPANTS OR DEATH.

Figure 4.1 Condensate Drain Plumbing

Condensate

Drain From

Boiler

Drain must be

open to allow

overflow if

blocked

Drain must

include trap

Nipple must

be cut.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 48 49

Brak uwag

Matrix M100V Dokumentacja Strona 12